Forklift battery manufacturers about all kinds of imported forklift battery maintenance  maintenance

Electric forklifts are electric forklifts, most of which work for batteries. The battery is one of the batteries, its function is to store limited electrical energy, in the right place. It works by converting chemical energy into electricity. Electric forklifts contain batteries in their batteries. Note: the battery does   cross! Because, the inside of the battery is generally 22 to 28% dilute sulfuric acid. When the battery is in place the electrolyte can flood the plate   there is a little space left, if the battery is placed horizontally, there will be a part of the electrode plate exposed to the air, which is very bad for the battery's polar plate,   the general battery observation hole   the top of the battery has an exhaust port with the outside world, so the battery horizontal electrolyte is easy to flow out.

At present, the general ordinary domestic battery can be charged 800 times right, good point of imported batteries can reach charge   discharge 1500 times, overcharging to produce a gas environment temperature is too low will make the battery charge is insufficient, which will affect the life of the battery. Therefore, the general requirements of the ambient temperature of about 25 degrees C, floating charging pressure value is also set according to this temperature of the practical application, the battery is generally within 5 degrees C one 35 degrees C range of charging, below 5 degrees C   higher than 35 degrees C will greatly reduce the capacity of the battery, shorten the battery life.

Battery in use, the release of the capacity generally requires   more than 80% of its rated capacity, when the battery capacity out of more than 80%, we say that the battery has a deep discharge when the battery release capacity of 80%, the capacity display on the forklift into the light area, at this time should immediately go to the charging place for charging. The harm of deep discharge to the battery: it is more easily vulcanized, it is easy to make the plate expansion deformation active substances fall off, resulting in a decrease in capacity, shortening the life.